WALCO® 40 – Wall Connector

WALCO® 40 – Wall Connector

Article number: K072
WALCO® 40
Consisting of: 1 pair WALCO 40, 4 CS-screws 10x60 mm
Price: for registered customers.
Amount: 25 sets per unit
1
The starting angle and the guide slot for the KNAPP®CS-retaining screws bring the connector pieces into position and draw them tight.
2
The KNAPP® CS-retaining screw allows for adjustments to the compression of joints.
3
WALCO® 40 is comprised of two structurally-identical connector pieces and is made from high-quality, bluegalvanized steel.
4
The 10 mm CS-screws with integrated drilling tip enable rapid fastening with screws; the reinforced shaft provides connections to be made in a forcelocking manner.
The starting angle and the guide slot for the KNAPP®CS-retaining screws bring the connector pieces into position and draw them tight.
The KNAPP® CS-retaining screw allows for adjustments to the compression of joints.
WALCO® 40 is comprised of two structurally-identical connector pieces and is made from high-quality, bluegalvanized steel.
The 10 mm CS-screws with integrated drilling tip enable rapid fastening with screws; the reinforced shaft provides connections to be made in a forcelocking manner.

WALCO® 40 (F2,Rk 10 kN*)

2 pc. SK 10x60 mm screws per connector plate (wall 1)

F2,Rk* 10 kN | F45,Rk* 8,6 kN

2 pc. SK 10x60 mm screws per connector plate (wall 1)

F2,Rk* 10 kN | F45,Rk* 8,6 kN

The WALCO® 40 set consists of two identical brackets made out of blue-galvanized steel. Commonly used gaskets can be installed on the prefabricated wall panels. When sliding the wall panels together, the brackets hook into each other in a dovetail-like manner and tighten up the connection. This allows the wall panels to be pre-manufactured to a large degree in a superior and advanced quality and then connected on site with no screwing or nailing needed.

System advantages:

  • Efficient wall connectors for timber frame and wood panel construction.
  • For timber widths from 60 mm and upwards.
  • Large degree of prefabrication – no screwing or nailing on-site.
  • Simple and easy – the wall panels are snapped together.
  • Stable from the first wall corner on
  • For timber structures according to DIN 1052 and Eurocode 5 (EN 1995-1-1).
  • ETA certified (even for hardwood).